SN74AS574N

SN74AS574N Overview

In the form of 20-DIP (0.300, 7.62mm), it has been packaged. D flip flop is embedded in the Tube package. T flip flop uses Tri-State, Non-Invertedas the output. In the configuration of the trigger, Positive Edgeis used. Through Holeis occupied by this electronic component. A supply voltage of 4.5V~5.5V is required for operation. Temperature is set to 0°C~70°C TA. This logic flip flop is classified as type D-Type. It is a type of FPGA belonging to the 74AS series. A frequency of 90MHzshould not be exceeded by its output. In total, it contains 1 elements. During its operation, it consumes 116mA quiescent energy. It has been determined that there have been 20 terminations. The 74AS574 family contains this object. It is powered from a supply voltage of 5V. Electronic devices of this type belong to the ASfamily. There is an electronic component mounted in the way of Through Hole. It is designed with 20 pins. There is a clock edge trigger type of Positive Edgeon this device. The part you are looking for is included in FF/Latches. There are 8bits in its design. Despite its superior flexibility, it relies on 8 circuits to achieve it. In order for the device to operate, it requires 5V power supplies. The D flip flop is embedded with 2ports. In order to achieve high efficiency, the supply voltage should be maintained at 5V. In addition to its maximum design flexibility, the output current of the T flip flop is 48mA. This input has 3lines.

SN74AS574N Features

Tube package
74AS series
20 pins
8 Bits
5V power supplies

SN74AS574N Applications

There are a lot of Texas Instruments SN74AS574N Flip Flops applications.

• Convert a momentary switch to a toggle switch
• Shift registers
• ESCC
• Storage Registers
• Buffer registers
• Parallel data storage
• Common Clocks
• Modulo – n – counter
• Single Up Count-Control Line
• Test & Measurement