SN74AC74DR

SN74AC74DR Overview

The package is in the form of 14-SOIC (0.154, 3.90mm Width). As part of the package Cut Tape (CT), it is embedded. Differentialis the output configured for it. It is configured with a trigger that uses Positive Edge. The electronic part is mounted in the way of Surface Mount. A supply voltage of 2V~6V is required for operation. In this case, the operating temperature is -40°C~85°C TA. The type of this D latch is D-Type. The 74ACseries comprises this type of FPGA. It should not exceed 160MHzin terms of its output frequency. It has been determined that there have been 14 terminations. This D latch belongs to the family of 74AC74. The power source is powered by 3V. There is 3pF input capacitance for this T flip flop. In terms of electronic devices, this device belongs to the ACfamily of devices. The electronic part is mounted in the way of Surface Mount. There are 14pins on it. There is a clock edge trigger type of Positive Edgeon this device. The RS flip flops belongs to FF/Latches base part number. In this case, the maximum supply voltage (Vsup) reaches 6V. Normal operation requires a supply voltage (Vsup) above 2V. Its superior flexibility is attributed to its use of 2 circuits. On the basis of its reliable performance, this D flip flop is well suited for use with TR. An electrical current of 3.3/5V volts is applied to it. With an output current of 24mA, it is possible to design the device in any way you want. As of now, there are 4input lines. Quiescent current is consumed by the D latch in the amount of 2μA.

SN74AC74DR Features

Cut Tape (CT) package
74AC series
14 pins
3.3/5V power supplies

SN74AC74DR Applications

There are a lot of Texas Instruments SN74AC74DR Flip Flops applications.

• Balanced 24 mA output drivers
• EMI reduction circuitry
• Frequency Divider circuits
• Latch-up performance
• Computers
• Frequency Dividers
• Shift Registers
• Circuit Design
• CMOS Process
• Instrumentation