CD74ACT174M

CD74ACT174M Overview

As a result, it is packaged as 16-SOIC (0.154, 3.90mm Width). A package named Tubeincludes it. T flip flop uses Non-Invertedas its output configuration. The trigger it is configured with uses Positive Edge. There is an electronic component mounted in the way of Surface Mount. The supply voltage is set to 4.5V~5.5V. It is operating at a temperature of -55°C~125°C TA. It is an electronic flip flop with the type D-Type. In terms of FPGAs, it belongs to the 74ACT series. There should be no greater frequency than 80MHzon its output. The list contains 1 elements. As a result, it consumes 8μA of quiescent current without being affected by external factors. 16terminations have occurred. The 74ACT174 family contains it. A voltage of 5V provides power to the D latch. A JK flip flop with a 10pFfarad input capacitance is used here. A device of this type belongs to the family of ACT. The electronic part is mounted in the way of Surface Mount. The 16pins are designed into the board. This device's clock edge trigger type is Positive Edge. The part is included in FF/Latch. The flip flop is designed with 6bits. Despite its superior flexibility, it relies on 7 circuits to achieve it. In order for the device to operate, it requires 5V power supplies. For high efficiency, the supply voltage should be set to 5V. With an output current of 24mA, it is possible to design the device in any way you want. There are 6 output lines on it.

CD74ACT174M Features

Tube package
74ACT series
16 pins
6 Bits
5V power supplies

CD74ACT174M Applications

There are a lot of Texas Instruments CD74ACT174M Flip Flops applications.

• Bounce elimination switch
• Dynamic threshold performance
• Patented noise
• Computers
• Automotive
• Frequency Dividers
• Balanced Propagation Delays
• Bus hold
• Load Control
• Buffer registers