54FCT574CTLB

54FCT574CTLB Overview

The flip flop is packaged in LCC. In 20terminations, a transmission line is terminated with a JK flip flop that matches its characteristic impedance. An input voltage of 5Vpowers the D latch. In this case, the D flip flop belongs to the FCTfamily. In this case, the electronic component is mounted in the way of Surface Mount. It is designed with 20 pins. A Positive Edgeclock edge trigger is used in this device. The RS flip flops belongs to FF/Latches base part number. The flip flop is designed with 8bits. The system runs on a power supply of 5V watts. There are 2 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. High efficiency requires the supply voltage to be maintained at 5V. Despite external influences, it consumes 10μAof quiescent current. Additionally, it is characterized by BROADSIDE VERSION OF 374. A -12mAis set for the high level output current. There is no low level output current set at 32mA. Operating temperatures should be lower than 125°C. Ideally, the operating temperature should be greater than -55°C. Normally, it operates with a voltage of 4.5VV as its minimum supply voltage. There is a maximum voltage support of 5.5V. There is a logic IC BUS DRIVER used in the D flip flop. The T flip flop is equipped with 1functions . 20pins are provided on the D latch.

54FCT574CTLB Features

20 pins
8 Bits
5V power supplies
1 Functions
20 pin count

54FCT574CTLB Applications

There are a lot of Integrated Device Technology (IDT) 54FCT574CTLB Flip Flops applications.

• High Performance Logic for test systems
• Bus hold
• Frequency division
• Automotive
• Storage Registers
• Modulo – n – counter
• Single Down Count-Control Line
• Circuit Design
• Patented noise
• Memory