54FCT374TLB

54FCT374TLB Overview

The flip flop is packaged in a case of LCC. The number of terminations is 20. An input voltage of 5Vpowers the D latch. It is a member of the FCTfamily of D flip flop. The electronic part is mounted in the way of Surface Mount. There are 20pins on it. Edge triggering is a type of triggering that allows a circuit to become active at the positive edge or the negative edge of the clock signal. The clock edge trigger type of this device is Positive Edge. There is a base part number FF/Latchesfor the RS flip flops. Flip flops designed with 8bits are used in this part. This D flip flop is well suited for TUBE based on its reliable performance. A total of 5V power supplies are needed to run it. The flip flop has 2ports embedded within it. For high efficiency, the supply voltage should be kept at 5V. As a result, it consumes 10μA of quiescent current without being affected by external factors. There is -12mA output current at the high level. There is 32mA output current at the low level. There should be a temperature below 125°Cduring operation. Ideally, the operating temperature should be greater than -55°C. The RS flip flop is designed to operate with a minimal supply voltage of 4.5VV. There is a maximum voltage support of 5.5V. BUS DRIVERis used as the logic IC in this D flip flop. The T flip flop is equipped with 1functions . The D latch is equipped with 20 pins.

54FCT374TLB Features

20 pins
8 Bits
5V power supplies
1 Functions
20 pin count

54FCT374TLB Applications

There are a lot of Integrated Device Technology (IDT) 54FCT374TLB Flip Flops applications.

• Buffered Clock
• Data Synchronizers
• Latch-up performance
• Memory
• Individual Asynchronous Resets
• Computers
• Shift Registers
• Storage registers
• Load Control
• Modulo – n – counter